Chassis Clearance Screen; Databank Summary Screen - ATH-Heinl ATH LUX 3D Bedienungsanleitung

CHASSIS CLEARANCE
SCREEN
After ROC has been performed, if the
selected vehicle requires some data-
bank values to be modified according to
the clearance of the chassis at specific
points, the chassis clearance window is
displayed.
The operator must select from the dis-
played tables, the clearance values that
most closely match those of the vehicle
in question.
To make the selection, proceed as de-
scribed in the "General considerations"
section.
In certain cases it is not possible to make
a selection; the displayed clearance val-
ues are "prescribed" values, i.e. the only
correct references for databank values,
to be achieved if necessary by applying
weights to the vehicle.
The following keys are active in this
window:
displays the on-line Help
F1
function
F2 goes back to the previous
screen
(or Enter) goes to the
F3
next screen in the
established operating
sequence.
Displays the menu with
F11
the contextual functions.
These are the menu options:
• End of work (Goes back to the starting
screen)
• Operating sequence (recalls the align-
ment execution setting screen, accord-
ing to the user's preferences)
• Help (recalls the Help contextual screen
on the screen where you are)
DATABANK SUMMARY
SCREEN
Shows the databank values for the
selected vehicle and allows the rim
diameter to be changed using the Page
á, Page â keys (fig.27).
The following keys are active in this
screen:
displays the on-line Help
F1
function
goes back to the
F2
previous screen
goes to the next screen
F3
in the established
operating sequence
Displays the menu with
F11
the contextual functions.
These are the menu options:
• End of work (Goes back to the
starting screen)
•
Setup (opens the contextual set-up
on the screen where you are)
•
Operating sequence (recalls the
alignment execution setting screen,
according to the user's preferences)
•
Help (recalls the Help contextual
screen on the screen where you are)