Transport, Storage And Handling; Ambient Conditions For Machine Storage; Installation And Set-Up - ATH-Heinl ATH LUX 3D Bedienungsanleitung

TRANSPORT,
STORAGE
AND HANDLING
Machine transport conditions
The aligner must be shipped in its
original packaging and stowed in the
position indicated on the outside.
• Packaging data:
•
1 wooden box
•
• Dimensions (LxWxH):
• 290x115x75 cm
•
• Weight:
• 189 kg
AMBIENT CONDITIONS
FOR MACHINE STORAGE
• Relative humidity: 20% ÷ 80%
• Temperature range:
WARNING
Do not stack other goods on top of the
packaging to avoid damaging it.
Handling
To move the packing, insert the forklift
tines into the slots in the base of the
packaging itself (pallet).
To move the machine, use the trim wheels;
to lift it, insert the forklift tines under the
lower platform of the wheeled cabinet,
keeping it near the trim wheels.
CAUTION
Always use suitable hoisting belts or
tested ropes.
‑
10° ÷ +60°C.
WARNING
This operation must be carried out very
carefully to prevent the unit from tipping
over or being damaged.
CAUTION
Handle with care: violent vibrations may
damage the equipment.
CAUTION
Keep the original packaging materials so
that the machine can be safely shipped
at a later date if necessary.
WARNING
Before moving the equipment, first
unplug the power supply cable from its
socket.

INSTALLATION AND SET-UP

Installation clearances
WARNING
All regulations in force concerning safety
at work must be complied with when
choosing the installation position.
The ground must be sturdy enough to
bear a weight equal to the sum of the
equipment weight plus the maximum
allowed load, including the supporting
base to the ground and the specific
securing devices.
Install the aligner at the desired work
position; make sure there is at least 25
cm between the rear part of the machine
and the nearest wall.
IMPORTANT: for the correct and safe
machine operation, the lighting level
in the place of use should be at least
300 lux.