Troubleshooting; Maintenance - ATH-Heinl ATH LUX 3D Bedienungsanleitung

Preferred.
Vehicles with hydro-pneumatic or intel-
ligent suspension systems.
• Adjust the vehicle with the engine running
and the suspensions at normal riding height.
Vehicles with fixed rear axle.
• Even if the rear axle is fixed, measure
the relative values to pick up on possible
misalignment; now adjust the front left
and right half-toes with respect to the
thrust axis in order to eliminate the
problem of a misaligned steering wheel.

TROUBLESHOOTING

Nothing turns on
Lack of or insufficient mains voltage.
Check the electrical circuit and connect
the machine correctly.
Plug inserted in the wrong socket.
Connect the plug properly.
Wrong power voltage selected.
Set the voltage selector to the correct
position, also check the transformer
power supply.
Monitor power switch OFF.
Set the monitor power switch to ON.
Keyboard
Keyboard not accepting commands.
Keyboard connection cable not connected.
Make sure the cable is inserted in the
computer inside the aligner.
Faulty keyboard.
call the service center.
Function key jammed (Alt, Alt Gr and
Ctrl keys)
• Check all the keys and release as
necessary.
Crooked steering wheels
Compensation performed incorrectly
Perform the compensation procedure
again making sure, in case 4WD cars, that
the steer wheels are not steered.
Calibrate.

MAINTENANCE

WARNING
The producer declines all liability for
claims deriving from the use of non-
original spare parts or accessories.
WARNING
Unplug the machine from the socket
and make sure that all moving parts
have been locked before performing any
adjustment or maintenance operation.
Do not remove or modify any parts of this
machine (except for servicing).
CAUTION
Keep the work area clean.
Never use compressed air and/or jets of
water to remove dirt or residues from
the machine.
When cleaning the area take all possible
measures to avoid spreading dust, as far
as possible.
• Put back the target with caution and in
a dry place, thus preventing wrong
adjustments that may result in wrong
measurements.
• Calibrate at least every six months.
• Keep the guides of the target coupling
clamps clean.
• Keep the turntables and the oscillating
footboards on which vehicle alignment
is performed perfectly clean and do not
oil or grease them.