Vehicle Preparation For Setting Operations - ATH-Heinl ATH LUX 3D Bedienungsanleitung

C) Databank values
D) Graph comparison between values
measured and databank values
E) Target level indications (LEVELS)
Representation of angles measured
F)
at the moment
G) HELP: used to recall the on-line help
Icon bar: icons to scroll the program
H)
Find further information on the
selected icon in the feedback bar
Feedback bar: displays a help
I)
message relating to the function of
the selected icon
L) Vehicle name bar: displays the name
of the vehicle selected from the
databank
When a vehicle is selected from the
databank, the selected market is
indicated
M) Status bar: displays the system
messages
N) Axle values difference: window that
indicates the value and the databank
reference of the difference of the
right and left values of the read angle.
This window is shown only when there
is a reference value in the databank
Working area: section of the screen
O)
that shows the information of the
job being done
VEHICLE PREPARATION
FOR SETTING
OPERATIONS
In order to align the wheels correctly, all
parts of the vehicle must be in compliance
with the manufacturer's specifications; it
is especially important to check tyre
pressure and eliminate clearance in
bearings and ball heads.
Position the vehicle over an inspection
pit or on a lift that is correctly equipped
for alignment operations. Make sure that
the turntables and oscillating footboards
are locked.
Mount the self-centering clamps on the
wheels and lock them on the rim using
the handles
For rims made of steel or with projecting
edges, the clamps should be secured from
the inside (1, fig. 22); in the case of alloy
rims, secure the clamps from the outside
(2, fig. 22); for rims with plastic covers,
secure the clamps from the inside with
the pins reversed (3, fig. 22).
If necessary, you can tap the wheel clamps
gently with the hand to fit the clamp
nose between the rim and the tyre bead.
For other types of support clamps with a
jaw or dedicated closing device, follow
the instructions attached and inserted in
the specific package.
Insert the targets on the pin of the self-
centering clamps
Measurement unit (Fig. 4)
The measurement unit of the aligner is
composed of two units consisting of a
camera and a card with infrared LED and
signal LED light, positioned at the edge
of the beam. In Figure 4 is shown one
measurement unit, in particular:
1) Protective Cover
2) Camera
3) Light indication Card, consisting of
infrared LEDs and LED indicator lights.
Light Indications cards (Fig. 5)
Around each camera is placed the card
equipped with infrared illuminators and
some colored LEDs, which are used to
provide useful information to the user.
The following table shows the
conditions indicated by colored LEDs:
LINK LED (bi-color, illuminated in red
or green):
There are 4 external LEDs that indicate
the status of the locking target.
RG1) LINK LED for the front left target
RG2) LINK LED for the front right target