VOLTCRAFT RS16 Bedienungsanleitung Seite 106

The following setting functions are available:
Different settings functions are available depending on the set rechargeable battery
type (LiPo, LiIon, LiFe, NiMH, NiCd, Pb). For example, the only setting function availab-
le for lithium rechargeable batteries is end charging voltage per cell.
Therefore, always first set the rechargeable battery type and other info so that the
charge can offer the appropriate setting functions.
Battery type
BATT TYPE
LiPo
Select the battery type („LiPo", „LiIon", „LiFe", „NiMH", „NiCd" or „Pb" here.
As previously stated, first make this setting so the charger can offer the appropriate
setting functions.
Battery voltage
BATT VOLTS
7.4V(2S)
Depending on the set battery type, you can set the battery voltage here.
You can not set any voltage, the increments depend on the nominal voltage of an
individual cell for the current battery type, see chapter 9.
For example, LiPo rechargeable batteries have a nominal voltage of 3.7 V per cell; the
battery voltage can only be set in increments of 3.7 V (3.7 V, 7.4 V, 11.1 V, etc.).
Charging current
CHARGE CURRENT
Set the desired charging current (0.1 ... 16.0 A) here. This setting depends on the rechargeab-
le battery at hand.
Please note that the charger's charging capacity does not exceed 180 W. For this
reason, the charger can not supply the maximum charging current in the case of rechar-
geable batteries with many cells.
106
2.2A