VOLTCRAFT RS16 Bedienungsanleitung Seite 100

• Move the control pad to the right „6" and hold for 3 seconds to activate cycle mode.
If the settings are incorrect or the charger detects an error, the charger will emit a
warning signal and the display shows the related information. To stop the warning signal
and return to the previous menu, move the control pad to the left „4".
During /charging/discharging, the display shows e.g.
the following information:
The rechargeable battery type is shown at the top left („NiMH" = NiMH rechargeable
battery), the charging/discharge current is shown at the top center and the rechargeable
battery's current voltage is shown at the top right.
The current cycle („C>D" = charge/discharge, „D>C" = discharge/charge) is shown at the
bottom left, elapsed charging/discharge time is shown in the center and to the right the
charged/discharged capacity in mAh.
• The charger emits a beep when cycle operation is complete (if this function has not been
deactivated).
To stop cycle mode, move the control pad to the left „4".
100
NiMH 1.0A
C>D 022:45 00890
7.42V