VOLTCRAFT RS16 Bedienungsanleitung Seite 98

• Move the control pad to the right „ 6" to change the value for the discharge current and
cutoff voltage. The discharge current starts flashing.
• Move the control pad upward „8" or downward „2" to set the discharge current.
• Move the control pad to the right „6" — the cutoff voltage starts flashing.
• Move the control pad upward „8" or downward „2" to set the cell count. Move the control
pad upward „8" or downward „2" to set the cutoff voltage.
Move the control pad to the right again — the display stops flashing. Follow the above
steps to change the discharge current or cutoff voltage, as desired.
• Move the control pad to the right „6" and hold for 3 seconds to activate the charging
program.
If the settings are incorrect or the charger detects an error, the charger will emit a
warning signal and the display shows the related information. To stop the warning signal
and return to the previous menu, move the control pad to the left „4".
During discharging, the display shows e.g. the follo-
wing information:
The rechargeable battery type is shown at the top left („NiMH" = NiMH rechargeable batte-
ry), the discharge current is shown at the top center and the rechargeable battery's current
voltage is shown at the top right.
The current charging program („DSC" = „DISCHARGE") is shown at the bottom left, elapsed
discharge time is shown in the center and to the right the discharged capacity in mAh.
• The charger emits a beep when discharging is complete (if this function has not been
deactivated).
To stop discharging, move the control pad to the left „4".
98
NiMH 0.1A
DSC 022:45 00890
7.42V