Safety Devices; Safety And Information Signs - Angelo Po 1N1TPEE Bedienhandbuch

Even if the equipment has all its safety devices,
if necessary, during the installation and con-
nection other safety devices may be supple-
mented in accordance with applicable laws.
Safety thermostat with automatic reset:
A)
cuts off the mains electricity supply to the
plate zone heating element in case of plate
overheating. Once the cause has been elimi-
nated and temperature is reduced, operation
is restored automatically.
Safety thermostat: cuts off the electricity
B)
supply to the oven in case of overheating.
Important
There are no indicator devices to signal that
the thermostat with automatic reset has
been tripped.
The illustration shows the position of the signs
provided.
Nameplate with manufacturer and
A)
appliance data.
General hazard: prima di eff ettuare qualsiasi
B)
tipo di intervento, leggere attentamente il
manuale.
General hazard: when washing the appliance
C)
do not point pressurised water jets at internal
parts.
General hazard: all relevant regulations must
D)
be complied with. "Install in compliance with
the relevant regulations and use in well venti-
lated premises only".
General hazard: all relevant regulations must
E)
be complied with. "No liability is accepted in
case of failure to comply with the installation
and commissioning instructions".
Burn hazard: watch out for hot surfaces.
F)
CE marking: this indicates that the equip-
G)
ment is compliant with all relevant laws
applicable to the product.
3326541_ut_GB

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

- 5 -
A
E
D
F
37M3202
C B
WEEE symbol: indicates that the appliance is
H)
subject to specifi c waste disposal regulations.
B
A
H
GB
G
ENGLISH