Philips PM 5330 Handbuch Seite 4

Press this SPECIAL key, followed by two digits:
SPECIAL 00
SPECIAL 01
SPECIAL 02
SPECIAL 10
SPECIAL 11
SPECIAL 12
SPECIAL 13
SPECIAL 14
SPECIAL 20
SPECIAL 21
SPECIAL 30
SPECIAL 31
SPECIAL 32
SPECIAL 33
SPECIAL 34
SPECIAL 35
SPECIAL 40
SPECIAL 41
SPECIAL 42
SPECIAL 43
SPECIAL 44
SPECIAL 50
SPECIAL 51
SPECIAL 52
SPECIAL 53
SPECIAL 54
SPECIAL. 55
SPECIAL 56
SPECIAL 57
SPECIAL 58
SPECIAL 59
SPECIAL 60
SPECIAL 61
SPECIAL 62
SPECIAL 63
SPECIAL 70
SPECIAL 71
SPECIAL 72
SPECIAL 75
SPECIAL 76
SPECIAL 90
SPECIAL 91
SPECIAL 99
SPECIAL >100
*1 i +
displays implemented options *1
displays software status *1
display test (all segments on) *1
RF output setting same before power off
always RF OFF when switching on the instrument
RF level, unit dBm
RF level, unit dBµV
RF level, unit dBmV
counter, impedance 1 M52
counter, impedance 50 52
reset to initial settings for stereo:
pilot on, pre-emphasis 50 µs
stereo, pilot off
stereo, pilot on
stereo, pre-emphasis off
stereo, pre-emphasis 50 µs
stereo, pre-emphasis 75 µs
reset to initial settings for RDS/ARI:
RDS deviation 1.25 kHz, RDS phase 90°, ARI DK off
RDS/ARI phase: 0°
RDS/ARI phase: 80°
RDS/ARI phase: 90°
RDS/ARI phase: 100°
RDS deviation 750 Hz (minimum)
RDS deviation 1.00 kHz
RDS deviation 1.25 kHz linitiaq
RDS deviation 1.50 kHz
RDS deviation 1.75 kHz
RDS deviation 2.00 kHz
RDS deviation 2.25 kHz
RDS deviation 2.50 kHz
RDS deviation 2.75 kHz
RDS deviation 3.00 kHz
RDS deviation 3.25 kHz
RDS deviation 3.50 kHz
RDS deviation 3.75 kHz
RDS deviation 4.00 kHz (maximum)
ARI: DK off (announcement identification), ARI Germany
ME 1/2 off (message signal), ARI USA
ARI: DK on; ARI USA: ME 1 on (message signal)
ARI: DK on; ARI USA: ME 2 on (message signal)
ARI: ARI Germany
ARI: ARI USA
reset off all special functions
reset of the instrument to a defined status *2
self calibration modulation/audio frequency
for service purposes only
see Chapter 3, Section 3.5.11