Connection Of A Lan Cable; Conversions/Changes/Spare Parts; Service/Repair; Operating Interruption - Conel CLEAR Serie Montage- Und Betriebsanleitung

6.9

CONNECTION OF A LAN CABLE

For remote control the device can be connected by a LAN cable with the CLEAR BOX (see chapter 10.5
"ACCESSORIES").
6.10

CONVERSIONS/CHANGES/SPARE PARTS

Only original spare parts may be used!
Unauthorised conversions and changes are forbidden for safety reasons. They may
impair the operation of the dosing pump. The imprinted approval marks are only
valid if original spare parts are used.
6.11

SERVICE/REPAIR

Before performing work on the dosing pump and water meter, that goes beyond
pure operational use, the dosing pump and water meter must be depressurised.
If this is ignored, the result may be uncontrolled egress of water resulting in water damage to the building/
home. Therefore the instructions given in chapter 5 "INSTALLATION" and chapter 8 "MAINTENANCE"
must be strictly observed.
Testing of functions:
If water is being drawn, a circle is displayed at the end of the first line of the display.
The JUL mineral solution in the mineral solution container decreases.
maximum
Under setting, the mineral solution container empties after about 48 m³ water consumption.
minimum
Under setting, the dosing solution is adequate for about 80 m³ water.
6.12

OPERATING INTERRUPTION

If a dosing pump must be disconnected or screwed off, the following instructions must al-
ways be followed:
/ If no more JUL mineral solution is to be dosed for an extended period, the remaining residual quantity
in the empty mineral solution container must be discarded and the mineral solution container thor-
oughly flushed out with water. Then the dosing pump must be operated for a reasonable period of time
with pure water.
61