Safety Information For Installation; Safety Information For Electrical Connection; Safety Information For Initial Start-Up - Webasto Live Einbauanweisung

2.3 Safety information for
installation
Installation and connection of the
–
charging station must only be carried
out by an electrician.
Only use the supplied installation ma-
–
terial.
The Webasto Live safety concept is
–
based on a power supply system that
is earthed at all times. The electrician
must ensure this requirement during
installation.
Do not install the charging station in
–
an explosion sensitive area (EX zone).
Install the charging station in such a
–
way that the charging cable does not
block any passageways.
Do not install the charging station in
–
areas subject to ammonia or air con-
taining ammonia.
Do not install the charging station in
–
a location where falling objects (e.g.
extension reel or tyres) can damage
the charging station.
The charging station is suitable for
–
use indoors as well as outdoors.
5110326C_OI-II_Webasto Live
Do not install the charging station in
–
the vicinity of water jets, e.g. car
wash installations, high pressure
cleaners or garden hoses.
Protect the charging station against
–
damage caused by sub-zero temper-
atures, hail or similar.
The charging station is suitable for
–
use in areas without access restric-
tions.
Protect the charging station from dir-
–
ect sunlight. The charging current
may be reduced at high temperatures
or charging may be disabled com-
pletely.
The installation location of the char-
–
ging station should be selected such
that vehicles cannot inadvertently col-
lide with it. Protective measures must
be implemented if the possibility of
damage cannot be ruled out.
Do not place the charging station into
–
operation if it is damaged during in-
stallation. A replacement will be re-
quired.
2.4 Safety information for
electrical connection
Comply with the locally applicable re-
–
quirements pertaining to electrical in-
stallations, fire protection, safety reg-
ulations and escape routes at the in-
tended installation location.
Each charging station must be protec-
–
ted with its own line circuit breaker
and residual current circuit breaker.
See "Criteria for the electrical connec-
tion on page 36".
Make sure that the electrical connec-
–
tions are de-energised before con-
necting the charging station to the
power supply.
Make sure that the correct supply
–
cable is used for the power connec-
tion.
Do not leave the charging station un-
–
attended with the cover open.
Register with the power supply com-
–
pany as required.
2.5 Safety information for
initial start-up
Initial start-up of the charging station
–
must be carried out only by an electri-
cian.
EN
33