General Safety Information - Webasto Live Einbauanweisung

environmental requirements. The device
must only be used in a technically faultless
EN condition.
Have any malfunctions that adversely affect
the safety of persons or of the device recti-
fied immediately by an electrician in accord-
ance with nationally applicable regulations.
NOTE
It is possible that the signalling in the
vehicle differs from that described
here. Always read the operating in-
structions of the respective vehicle
manufacturer and always observe
these.
2.2

General safety information

Hazardous voltages are present within
–
the casing.
The charging station does not have its
–
own main ON/OFF switch. The pro-
tective devices installed in the power
supply system are therefore also used
to disconnect the power supply.
Check charging station for visual dam-
–
age before use. Do not use the char-
ging station if damaged.
Installation, electrical connection and
–
initial operation of the charging sta-
tion must only be carried out by an
electrician.
32
Do not remove the cover of the in-
–
stallation area whilst in operation.
Do not remove markings, warning
–
symbols and the type label from the
charging station.
The charging cable must only be re-
–
placed by an electrician in accordance
with the installation instructions.
It is strictly prohibited to connect
–
other equipment/devices to the char-
ging station.
When not in use, store the charging
–
cable in the designated holder and
lock the charging coupling in the
charging station. Loosely wind the
charging cable around the charging
station casing so that it does not
touch the ground.
Make sure that the charging cable
–
and coupling cannot be driven over,
trapped and are protected from any
other hazards.
Immediately notify Webasto Customer
–
Service if the charging station, char-
ging cable or the charging coupling
are damaged. Do not continue using
the charging station.
Prevent the charging cable and coup-
–
ling from coming in contact with ex-
ternal heat sources, water, dirt and
chemicals.
The Webasto Live charging station
–
also meters the plug-in cycles of the
charge coupling for service purposes
and after 10,000 plug-in cycles, dis-
plays a note on the web interface that
an electrician needs to inspect the
plug contacts on the charge coupling
for any signs of wear. If any signs of
wear are discovered, the electrician
must replace the affected charging
cables with genuine Webasto spare
parts.
Do not attach extension cables or ad-
–
apters to the charging cable.
Remove the charging cable by pulling
–
on the charging coupling only.
Never clean the charging station with
–
a high-pressure cleaner or similar
device.
Switch off the power supply before
–
cleaning the charging sockets.
The charging cable must not be sub-
–
jected to any strain during use.
Ensure only persons who have read
–
these operating instructions have ac-
cess to the charging station.
5110326C_OI-II_Webasto Live