Network Check - VCS VideoJet 10 Handbuch

Maintenance and Upgrades

Network check

"
"
Repair
VideoJet 10
The connection between two IP addresses can be checked by
means of the ping command. In this way it is possible to check
whether a unit is active on the network.
Open the DOS input window.
Enter the command ping followed by the address of the unit.
When the unit is found, the response: Reply from..., followed
by the number of bytes transmitted and the time taken for the trans-
mission in ms is displayed. If this message is not displayed, the unit
is not accessible over the network. This can be due to the following
reasons:
The network connection to the unit is not OK. In this case, check
!
out the cable connections.
The unit is not correctly integrated into the network. Check the IP
!
address, subnet mask and, if necessary, the gateway IP.
Warning!
Never open the housing of the VideoJet 10. The unit has no user
serviceable parts, which can be repaired or exchanged.
Ensure that only qualified, specialist personnel (electrical techni-
cians) are permitted to carry out maintenance or repair work or con-
tact the VCS Service centre.
7
107