VCS VideoJet 10 Handbuch Seite 152

Command entry
IP address
"
"
"
"
"
VideoJet 10
After the connection has been established, call up the main menu.
Additional submenus and functions are called up using the
onscreen commands.
Switch local echo off so that values entered are not repeated.
!
Enter only one command at a time.
!
When a value is entered (e.g. IP address) recheck the charac-
!
ters entered and only then press the [ENTER] key to transmit the
value to the VideoJet 10.
To operate the VideoJet 10 on a network, an IP address valid for the
network must be provided.
The following address has been preset at the factory:
Transmitter: 192.168.0.1
Receiver: 192.168.0.2
Start up the terminal programm, e.g. HyperTerminal.
Enter user name service. The main menu will be displayed.
Enter I to open the IP menu.
The submenu for network configuration will be displayed.
Enter i. The current IP address will be displayed; you will be
required to enter a new IP address.
Enter the new IP address and press [ENTER]. The new IP address
will be displayed and is immediately valid.
Installation
27