VCS VideoJet 10 Handbuch Seite 222

Image quality
"
"
"
Alarm
Output
"
Control functions
VideoJet 10
With established connections, the video image is displayed in the
middle of the browser window. Depending upon configuration, other
information may also appear in the display (see page 43).
The VideoJet 10 provides either a live image (MPEG-4 format) or
single video frames in JPEG format.
Click on the link MPEG-4 in the navigation bar at the top of the
screen in order to display or decode the video sequences in the cor-
responding image format
or
click on the link M-JPEG in the navigation bar at the top of the
screen in order to display or decode the single video frames in the
corresponding image format.
Above the video image, click on one of the links 352x288 or
704x576, to display the image in the selected resolution.
In the event of an alarm, the alarm symbol is displayed in red along
with the video image. The display of alarms and other details
depends on the configuration of the unit (see page 71).
Depending upon configuration, equipment can be switched by the
relay of the VideoJet 10 (e.g. a floodlight or door opener).
To activate the relay output, click on the relay symbol beside the
video image. The symbol will be displayed in red when the relay is
activated.
Possibilities for the control of peripheral equipment
(e.g. pan and tilt heads) are dependent upon the
installed equipment type and on the configuration
of the VideoJet 10.
If a controlled unit is connected to a VideoJet 10
and configured, the active elements for the control
of the peripheral unit (e.g. a dome camera) will be
displayed alongside the video image.
Operation
97