Crawler Function (4Ws/Brk); Channel 4 Trim (Trm4) - ROBBE-Futaba Megatech T3PL Bedienungsanleitung

12.7

crawler Function (4Ws/BrK)

This function is particularly useful for Trial vehicles, when the Crawler
function is active, the steering mechanism is mixed from channels 1
and 4. The front wheel steering will be controlled by channel 1 and the
rear wheel steering by channel 4.
sists of three levels, illustrated as follows:
The settings are made as usual with the DT1 key to select. The "INH"
menu deactivates the function. In the "4WS" menu, channel 4 controls
the second steering servo, which depending upon the servo direction
(REV) runs in the same or opposite sense to the front steering servo.
Activating the "BRK" menu, channel 4 will be set as a brake servo.
note:
Once the "4Ws" or "BrK" menus are activated, the setting func-
tions for channel 4 (trim, epa and servo reverse) will be displayed.

12.8 channel 4 trim (trM4)

This menu carries out the trimming of chan-
nel 4. This works exactly like the previous
trim settings for channels 1-2.
Failsafe position setting for throttle (F/s)
12.9
Navigate using "Select" key to the "F/S" menu point.
Press the DT1 trim key to turn on the function.
Move and hold the throttle trigger in the F/S position (idle) which will be
used in case of interference. Press the DT2 trim key.
note:
fter switching off the receiver power, the stored F/s settings in the
receiver will be lost! therefore the Failsafe position in the receiver
must be stored once more! switch the tx on and then the rx.
Megatech
T h e m e n u c o n -
12
T3PL
2,4 GHz
No. F 3033