Number Of Scans; Colour Systems - ColorLite XS1 Bedienungsanleitung

Three ∆E ranges can be defined
using the two ∆E limits. Pass, fail
or an intermediate ranges. Select
the limit value using the navigation
keys.
Alternatively limits for the L*,
a*, b* as a positive or negative
differences can be selected, to
define the "Pass/Fail" result. The
limit values are displayed in the
results window.
Change of stored limit values:
1. Download the standard you want to change via the
menu item „select standards" in the „Measure"
menu.
2. Select „Settings" and then „Pass / Fail" Function
3. Change the limits as before.
If you leave the menu, a message appears asking if the
limit of the loaded standards should be changed. Press
Enter to confirm. This query window only appears if a
standard has been loaded from memory.
6.6

Number of scans

For measuring inhomogeneous samples such as granules
or structured surfaces such leather, it is possible to
increase the number of scans from which the colour values
are calculated.
6.7

Colour systems

The ColorLite sph xs1 offers the possibility to display
the measured colour data in different colour systems or
values. In the menu "Settings" - "Colour systems" a
list of available systems are listed. Up to 8 colour systems
can be selected at one time for the sample values. In the
same way up to 6 systems can be selected to display the
standard results and 1 for the memory viewer.
ColorLite GmbH | sph870/sph900
Following scan values are
available; 1 (off), 3, 5, 10, 15,
20. When selected an average is
automatically calculated. Between
each scan the standard deviation is
displayed.
"Number of scans" is located
in the "Settings" menu. The
currently set value is displayed.
The default setting is "1". Set the
value using the navigation keys.
Scans
73