Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Cooper Surgical LEEP PRECISION LP-10-120 Bedienungsanleitung

Section 16 Guidance and Manufacturer's Declaration –
Electromagnetic Immunity
The CooperSurgical LEEP PRECISION Integrated Systems are intended for use in the electromagnetic
environment specified below. The customer or the end user of the CooperSurgical LEEP PRECISION
Integrated System should assure that it is used in such an environment .
Immunity Test
Electromagnetic
discharge (ESD)
IEC 61000-4-2
Electrical fast transient/
burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions, and voltage
variations on power
supply input lines
IEC 61000-4-11
Power frequency
(50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE U is the a .c . mains voltage prior to application of the test level; in this case, 230 V .
T
IEC 60601
Test Level
±6 kV contact ±6 kV contact
±8 kV air ±8 kV air
±2 kV for power ±2 kV for power
supply lines supply lines
±1 kV for input/output ±1 kV for input/
lines output lines
±1 kV differential ±1 kV differential
mode mode
±2 kV common mode ±2 kV common mode
<5% U <5% U
T
(>95% dip in U ) (>95% dip in U
T
for 0 .5 cycle for 0 .5 cycle
40% U 40% U
T
(60% dip in U ) (60% dip in U
T
for 5 cycles for 5 cycles
70% U 70% U
T
(30% dip in U ) (30% dip in U
T
for 25 cycles for 25 cycles
<5% U <5% U
T
(>95% dip in U ) (>95% dip in U
T
for 5 sec
for 5 sec
3 A/m 3 A/m
Compliance Level
Floors should be wood, concrete,
or ceramic tile. If floors are
covered with synthetic material,
the relative humidity should be at
least 30 percent .
Mains power quality should be
that of a typical commercial or
hospital environment .
Mains power quality should be
that of a typical commercial or
hospital environment .
Mains power quality should be
T
) that of a typical commercial or
T
hospital environment .
If the user of the CooperSurgical
T
) LEEP PRECISION Integrated
T
System requires continued
operation during power mains
interruptions, it is recommended
T
) that the CooperSurgical
T
LEEP PRECISION Integrated
System be powered from an
uninterruptible power supply or
T
) a battery .
T
Power frequency magnetic fields
should be at levels characteristic
of a typical location in a typical
commercial or hospital
environment .
36
Electromagnetic
Environmental Guidance