Front And Rear Panels Of The Leep Precision Generator And Integration Unit; Front Panel Of The Leep Precision Generator; Indicator Lights - Cooper Surgical LEEP PRECISION LP-10-120 Bedienungsanleitung

Section 4 Front and Rear Panels of the LEEP PRECISION Generator
and Integration Unit

4.1 Front Panel of the LEEP PRECISION Generator

(Cart not shown)
1
Controls
Operator Pushbuttons
a) PURGE* Turns LEEP PRECISION Smoke Evacuator
b) RAISE
c) LOWER
d) WAIT
e) BLEND
f) CUT
g) COAG
Foot Switch Socket
A/C Power (rear panel)
Active Electrode Socket
Dispersive Electrode Socket
Remote Pencil Buttons (not shown)
* The LEEP PRECISION Smoke Evacuator may also be tested or used without the LEEP PRECISION Generator output
by pressing the "Purge Button" on the front panel. The motor will stay on for five (5) seconds after the button is released.
Most purge operations (removing excess smoke) take only a few seconds .
4
1a-1g
Figure 6 (Front Panel)
1
on for 5 sec .
Increases power setting
Decreases power setting
Standby mode
Cutting mode selection
Cutting mode selection
Cutting mode selection
5
6
7
8
5

Indicator Lights

WAIT
CUT
BLEND = Yellow
COAG = Blue
Power Indications
Digital LED Display
Acoustical
Piezo Annunciator (internal)
PATIENT PAD LOOSE
R/F LEAKAGE ERROR
SYSTEM READY
R/F ON
12
(Colored, numbered boxes are also
located later in this manual .)
2
= Red
= Yellow
3
4
7
8