La Crosse Technology WEATHER MASTER Bedienungsanleitung Seite 36

7.0 Timer Mode - Setting the User Preset Value
the time in which the timer
will countdown from
(hour, minute and second)
Timer Mode
hold
[M]
hour minute
Settin g Seq u en ce
[S/S] / [R]
Change the
setting value
Setting the User Preset Value
7.1 Countdown Timer Mode - Using the Timer
T im er Disp lay
(T im er Set as 3 Min)
Using the Countdown Timer
Digits selected
(flashing)
Settin g Disp lay
Second
hold [S/S] / [R]
Change the
setting value at
a higher speed
digits start
counting
Co u n tin g Disp lay
digits stop
counting
Sto p Co u n tin g Disp lay
digits start
counting
again
Co u n tin g Disp lay
25
How to Set the User Preset Value
● Hold [M] for about 2 seconds in the Timer timer will
countdown from mode to select the setting display.
(hour, minute and second)
● On the setting display, press [M] to switch the
setting selection following the adjacent diagram.
● When the digits are flashing (selected), press the
[S/S] or [R] button to change the setting value. (Hold
the button to change the setting value ata higher
speed).
How to Use the Timer
● When the Timer is set, press [S/S] to start the timer.
Press [S/S] once again to stop the timer.
● The time to 'Zero' will be shown on the display
continuously.
● In the last 10 second, the Station will beep every
second. When the counting reaches zero, the beep
sound will last for 30 seconds.
● Pressing any button in this period will terminate the
beep sound before the preset time.
● The last counting value will be loaded automatically by
the end of the beep sound.
How to Reload the Timer
● To reload the timer (the existing preset counting time)
for a new counting, press [R] when the timer has been
stopped.
● To start a new counting using a new preset counting
time, set the timer again.