Drawings - MORIA Epi-K Benutzerhandbuch

11

DRAWINGS

A. Disposable head
1 Threaded shaft
2 ONE EPI
3 Separator housing
4 Slide
5 Separator
6 Aplanating plate
B. Suction ring
1 Vacuum port
2 Threaded shaft
3 Guiding
4 Stopper with engraved stop value
5 Handle
C. Setting the stopper
1 Spanner
2 Stopper
D. Connecting the suction ring to the aspiration
tubing
1 Aspiration tubing end
2 Tubing of the suction ring
E. Motor
1 Motor housing
2 Motor cord
3 Threaded ring
4 Oscillation motor shaft
5 Head alignment guide
6 Advance drive
F. Mounting the head on the motor
1 Open the pack containing the disposable
head and suction ring
2 Screw the head clockwise onto the threaded
motor shaft.
3 Check that the head is screwed on tightly to
the motor. There should be no rotation of the
head.
G. Mounting the head on the suction ring
1 When inserting the head in the rails of the
suction ring, the handpiece must be at a 45°
angle from the threaded shaft of the ring
2 Once the head properly inserted, slightly
reduce the angle from 45° to 0°.
12
MORIA #65044-B-02.2017
H. Alignment of the head, motor and suction ring
1 Proper assembly
2 Incorrect alignment
3 Alignment of the threaded shaft with the
motor
I. Cleaning the motor
1 Disposable brush (#19149)
2 Maximum submersion
3 Sterile distilled water