Drawings - MORIA One Use-Plus Benutzerhandbuch

11 DRAWINGS

A. Disposable head
1 Threaded shaft
2 Head calibration value
3 Blade housing
4 Slide
5 Blade
6 Aplanating plate
B. Suction ring
1 Vacuum connection
2 Stop setting screw
3 Stop
4 Guiding
5 Ring size
6 Threaded shaft
C. Setting the stopper
1 Step 1: Loosen safety screw
2 Step 2: Turn stop to desired value (the
desired stop value must face the ring).
Tighten screw with fingers
D. Connecting the suction ring to the aspiration
tubing
1 Aspiration tubing end
2 Suction ring end
E. Motor
1 Motor housing
2 Motor cord
3 Threaded ring
4 Oscillation motor shaft
5 Head alignment guide
6 Advance drive
F. Mounting the head on the motor
1 Screw the head clockwise onto the
threaded motor shaft.
2 Check that the head is screwed on tightly to
the motor.
3 There should be no rotation of the head.
G. Mounting the head on the suction ring
1 When inserting the head in the rails of the
suction ring, the handpiece must be at a
45° angle from the threaded shaft of the
ring
2 Once the head properly inserted, slightly
reduce the angle from 45° to 0°
H. Alignment of the head, motor and suction
ring
1 Proper assembly
2 Incorrect alignment
3 Alignment of the threaded shaft with the
motor
I. Cleaning the motor
1 Disposable brush (#19149)
2 Maximum submersion
3 Sterile distilled water
#65040-F-02.2017
13
MORIA