ConMed Linvatec VP4726 Bedienungsanleitung Seite 46

W41-147-004AA.book Page 42 Wednesday, February 18, 2009 2:47 PM
WARNINGS:
E
1. Portable and mobile RF communications equipment can affect Medical Electrical
Equipment.
2. Use of accessories, transducers, and cables other than those specified, with the exception of
transducers and cables sold by the manufacturer of the equipment as replacement parts for
internal components, may result in increased emissions and decreased immunity of the
equipment or system.
3. The console should not be used adjacent to or stacked with other equipment, and that if
adjacent or stacked use is necessary, the equipment or system should be observed to verify
normal operation in the configuration in which it is intended to be used.
4. Under extreme conditions of primary power voltage sag [Primary voltage less than 60% of
mains] the device may require operator intervention to recover lost image. Device may have
to be restarted by pressing On/Standby Switch.
Table 3: Guidance and Manufacturer's Declaration - Electromagnetic Immunity
The ConMed Linvatec VP4726 and VP4726F Monitors are intended for use in the electromagnetic
environment specified below. The customer or the user of the VP4726 or VP4726F Monitor should
Emissions Test
RF Emissions
CISPR 11
RF Emissions
CISPR 11
Harmonic Emissions
IEC 61000-3-2
Voltage fluctuations
/ flicker emissions
IEC 61000-3-3
assure it is used in such an environment.
Compliance Electromagnetic environment - guidance
Group 1 The VP4726 and VP4726F Monitors use RF energy
only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
Class B
The VP4726 and VP4726F Monitors are suitable for
use in all establishments, including domestic
Class D
establishments and those directly connected to the
public low-voltage power supply network that
supplies buildings used for domestic purposes.
Complies
E-42