Engine Oil; Air Filter - Textron Jacobsen Tri-King Sicherheits-, Betriebs- Und Wartungshandbuch

8.3

ENGINE OIL ______________________________________________________________

Check the engine oil at the start of each day, before starting
the engine. If the oil level is low, remove oil filler cap, and
add oil as required.
Perform initial oil change after first 50 hours of operation and
every 100 hours thereafter. See Engine Manual.
Use only engine oils with API classification CD/CE.
Above 77°F (25°C) SAE 30W or SAE10W30/10W40
32 to 77°F (0 to 25°C) SAE 20W or SAE 10W30/10W40
Below 32° (0°C) SAE10W or SAE 10W30/10W40
8.4

AIR FILTER _______________________________________________________________

Check the service indicator daily. If red band appears in the
window (C) replace the element.
Do not remove the element for inspection or cleaning.
Unnecessary removal of the filter increases the risk of
injecting dust and other impurities into the engine.
When service is required, first clean the outside of the filter
housing; then remove the old element as gently as possible
and discard.
1. Carefully clean the inside of the filter housing without
allowing dust into the air intake.
2. Inspect the new element. Do not use a damaged
element and never use an incorrect element.
3. Assemble the new element and make sure it seats
properly. Reset the indicator by depressing button (D).
4. Reassemble cap making sure it seals completely
around the filter housing. Dust evacuator (E) must be
facing down.
5. Check all hoses and air ducts. Tighten hose clamps.
MAINTENANCE
Safe Operating Range
E
8
Figure 8A
D
C
Figure 8B
33