Troubleshooting; Disposal - Silvercrest SKGL 2000 A1 Bedienungsanleitung

Troubleshooting

This section contains important information on fault identification and rectification.
The following table will help you to identify and rectify minor malfunctions.
NOTE
► If the appliance malfunctions, the corresponding error code will be shown
on the display. You hear beeps and all buttons are locked. It is not possible
to make any entries via the control panel
below.
Fault
The appliance will not
switch on.
ER1 appears on the
display.
ER2 appears on the
display.
ER3 appears on the
display.
NOTE
► If you are unable to resolve the problem by applying any of the aforemen-
tioned methods, please contact the Customer Service department.

Disposal

Never dispose of the appliance in your normal domestic waste.
This product is subject to the provisions of European Directive
2012/19/EU-WEEE (Waste Electrical and Electronic Equipment).
Dispose of the appliance via an approved disposal company or your municipal
waste facility. Please observe the currently applicable regulations. Please contact
your waste disposal facility if you are in any doubt.
■ 50 │ GB │ IE
Possible cause
The plug is
not connected.
The socket is not
supplying any power.
The appliance is
damaged.
There is a short circuit in
the system.
The lower hotplate
has not been correctly
attached.
The temperature of the
hotplates is over
320°C. The appliance
has overheated.
. Please follow the instructions
Remedy
Connect the mains adapter
correctly to the appliance.
Check the house mains fuse.
Contact the Customer Service
department.
Disconnect the plug from the mains
power socket and contact the Cus-
tomer Service department.
Ensure that the lower hotplate
correctly fitted.
Remove the plug from the mains
power socket. Wait until the appliance
has cooled down completely and then
reconnect the appliance to a mains
power socket.
SKGL 2000 A1
is