Ip Arp-Inspection Auto-Disable; Ip Arp-Inspection Limit - Hirschmann Hios-3S Rsp Referenzhandbuch

Dynamic ARP Inspection

12.4.2 ip arp-inspection auto-disable

Enables or disables the auto-disable feature for an interface, applicable
when the ARP packet rate exceeds the limit.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip arp-inspection auto-disable

no ip arp-inspection auto-disable
Disable the option

Mode: Interface Range Mode

Privilege Level: Operator

Format: no ip arp-inspection auto-disable

12.4.3 ip arp-inspection limit

This command configures an interface for a maximum ARP packet rate in a
burst interval, or disables it. If the rate of ARP packets exceed this limit in
consecutive intervals then all further packets are dropped. If that happens
and additionally the auto-disable feature is enabled, then the port is disabled
automatically.

Mode: Interface Range Mode

Privilege Level: Operator

Format: ip arp-inspection limit <P-1> [<P-2>]
Parameter Value
-1..300
P-1
1..15
P-2
210
Meaning
Specifies the rate limit value (in packets
per seconds, pps) for Dynamic ARP Inspection
(DAI) purposes. The value -1 switches rate
limiting off.
Specifies the burst interval value for Dyna-
mic ARP Inspection (DAI) purposes. Because
this parameter is optional it leaves unchan-
ged if omitted.
12.4 ip
RM CLI HiOS-3S RSP
Release 6.1 09/2016