Hirschmann HiOS-3S RSP Referenzhandbuch Seite 1488

Parallel Redundancy Protocol
(PRP) (hardwareabhängig)
operation: Enable or disable the PRP instance.
port-a: Enable or disable the first port of the PRP line.
port-b: Enable or disable the second port of the PRP line.
supervision: Configure the PRP supervision tx and rx packet handling.
evaluate: Enable or disable evaluation of received supervision packets.
send: Enable or disable sending of supervision packets.
redbox-exclusively: Enable sending of supervision packets for this
RedBox exclusively. Use the no form of the command to send supervision
packets for each connected VDAN and this RedBox (if send is enabled).
speed: Configure the speed of LRE interfaces.
Parameter Value
P-1 1..1
100
P-2
1000

no prp instance
Disable the option

Mode: Global Config Mode

Privilege Level: Operator

Format: no prp instance <P-1> operation port-a port-b
supervision evaluate send redbox-exclusively speed
RM CLI HiOS-3S RSP
Release 6.1 09/2016
55.1 prp (hardwareabhängig)
Meaning
Enter PRP instance number (only 1 suppor-
ted).
100 MBit/s
1000 MBit/s
669