Starting Up The Truck; Checks And Operations To Be Performed Before Starting Daily Work; Adjusting The Driver Seat - Jungheinrich EFG-Vac 25 Betriebsanleitung

3

Starting up the truck

f
Before the truck may be put into operation, may be operated or a load unit may be
lifted, the driver must ensure that nobody is within the danger area and that the truck
is in operationally reliable condition.
3.1

Checks and operations to be performed before starting daily work

Prior to setting the truck into operation the driver must confirm the operationally
reliable condition. Prior to starting work the following items must be verified:
–– operation of the service and parking brakes respectively the automatic brake
(Emergency Stop)
–– no damages at the fork securing device against lifting out and shifting
–– no visible damages at the load-carrying unit (bends, cracks, severe abrasion)
–– operation of the warning equipment
3.2

Adjusting the driver seat

A
To achieve optimum seat cushioning the driver seat must be adjusted to the driver’'s
weight.
When adjusting the driver seat to the driver’'s weight the seat must not be loaded!
Adjusting the weight:
–– Pull weight setting “"Driver seat”" (40) in
arrow direction to the limit and guide
back again.
A
The prior weight setting is reset to the
minimum value. The seat cushioning
can be set in the range from 50 to
130 kg.
–– Pull weight setting “"Driver seat”" (40)
again in arrow direction until the
weight display “"Driver seat”" (41)
shows the
mark. Subsequently guide back the
weight setting “"Driver seat”".
–– Sit on the driver seat.
E 8
corresponding weight
42
41
39
40