Jungheinrich EFG-Vac 25 Betriebsanleitung Seite 70

Electr. 7.1 Check function of instruments and indicators
system:
7.2 Check cables for secure connection and damage
7.3 Check cable guides for function and damage
7.4 Check the warning devices and safety circuits for correct
7.5 Check contactor
7.6 Check fuses for correct amperage
7.7 Clean installation space of electronics and cooling fins
7.8 Read out and clear error memory
Electric 8.1 Check the motor for secure attachment
motors:
8.2 Check fan for correct function
8.3 Clean motor cooling fins
Battery: 9.1 Check battery cables for damage and replace, if
9.2 Check acid density, acid level, and cell voltage
9.3 Check terminals for secure attachment and apply
9.4 Clean battery plug connections, check for tight seat
Lifting mast: 10.1 Apply lubricating grease to slide way and lateral
10.2 Check lifting chains for wear and adjust.
10.3 Grease lifting chains and check tension.
10.4 Check lifting mast attachment
10.5 Check tilting cylinder bearing and secure attachment
10.6 Check fork arms and fork arm carriage for wear and
10.7 Perform sight check of rollers, sliding elements, and
10.8
10.9
General 11.1 Check electrical system for earth fault according to
measure-
ments:
11.2 Check travel speed and braking distance
11.3 Check lifting and lowering speed
Demon- 12.1 Perform trial run under nominal load
stration:
12.2 Upon completion of servicing operations, demonstrate
function
necessary
grease
stopping face of the guide rollers in the lifting mast
profiles.
damage
stops
Check tilting angle of lifting mast.
Check uniform extension of both tilting cylinders.
Check mast play and adjust lateral play by means of
shims, if necessary.
VDI 2511
the vehicle to the person responsible
Maintenance intervals
t
Standard = W M M M
1 6 12 24
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
F 5