Jungheinrich EFG-Vac 25 Betriebsanleitung Seite 46

Instructions for using the restrain belt
Before starting the industrial truck, pull
the belt smoothly out from the retractor,
pull it tight to the body over the thighs
and latch it with the buckle.
f
The belt must not be twisted when put
on!
When operating the industrial truck (e. g.
travelling, lifting, lowering, etc.), sit back
as much as possible, so that your back
is leaning against the backrest.
The automatic locking retractor allows
sufficient freedom of shifting around on
the seat.
f
When sitting on the front edge of the
seat, the belt is rolled out too long, thus
providing not enough protection.
A
Only use the belt to secure persons.
–– After use, push the red button and
hold the latch with your hand while the
belt is being retracted.
A
The latch hitting the housing can trigger the automatic locking mechanism. In that
case the belt cannot be rolled out.
Releasing the block:
–– Pull the belt with increased force 10 to 15 mm out of the housing.
–– Allow belt to retract in order to release the automatic locking.
The belt can now be rolled out again.
Starting the industrial truck on steep slopes
The automatic blocking retractor locks the belt in the retractor when the truck is
positioned on a steep slope. In such a situation the belt can no longer be pulled out
from the retractor.
A
Carefully move the truck away from the steep slope and then put on the belt.
E 11