Maintenance Checklist Efg-Vac - Jungheinrich EFG-Vac 25 Betriebsanleitung

4

Maintenance checklist EFG-Vac

A
The maintenance intervals refer to normal service conditions. In case of aggravated
conditions, the intervals must be reduced as required.
Chassis/ 1.1 Check all load bearing elements for damage
super- 1.2 Check all bolted connections
structure: 1.3 Check trailer coupling
1.4 Check overhead guard for damages and secure
1.5 Check safety belt for damages and function
1.6 Check retaining system (option) for damages and
1.7 Check is label are present, readable, and valid
Drive: 2.1 Check transmission for noise and leaks
2.2 Check transmission oil level
2.3 Check pedal mechanism and adjust and grease, if
2.4 Change transmission oil
Wheels: 3.1 Check wheels for wear and damage
3.2 Check tyre pressure
3.3 Check bearing and secure attachment
3.4 Renew wheel bearing greasing of front and rear tyres
Steering: 4.1 Check hydraulic components for function and leaks
4.2 Grease all bearings of the steering axle (wheel bearing,
4.3 Check steering axle, king pin, and stops for wear and
4.4 Clean steering angle sensor with compressed air
Brake 5.1 Performance and adjustment check
system: 5.2 Check brake mechanism and adjust and grease, if
5.3 Check brake lines, connections, and oil level of the
5.4 Change mineral oil of the brake system
5.5 Measure holding pressure of spring-loaded brake
5.6 Check brake fluid level (mineral oil)
Hydr. system: 6.1 Check connections for leaks and damage
6.2 Check ventilation and aeration filter at hydraulics tank
6.3 Check oil level
6.4 Check hydraulic cylinders for leaks, damage, and
6.5 Check hose line for correct function and damage
6.6 Change filter cartridge (hydraulic oil and aeration filter)
6.7 Change hydraulic oil
6.8 Check pressure relief valves for correct function
6.9 Change vacuum filter (steering)
F 4
attachment
function
required
and readjust wheel bearings.
king pin, steering arm and swivel) according to the
lubrication schedule with a conventional grease gun at
least after 500 hours.
deformation
required
brake system
secure attachment
Maintenance intervals
t
Standard = W M M M
1 6 12 24
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t
t