F Maintenance Of The Fork Lift Truck; Operational Safety And Environmental Protection; Safety Regulations Applicable To Truck Maintenance - Jungheinrich EFG-Vac 25 Betriebsanleitung

F Maintenance of the fork lift truck

1

Operational safety and environmental protection

The checks and servicing operations contained in this chapter must be performed in
accordance with the intervals as indicated in the servicing checklists.
f
Modifications of fork lift truck assemblies, especially of the safety installations, are not
permitted. On no account must the operational speeds of the truck be changed.
m
Only original spare parts have been certified by our quality assurance service. To
ensure safe and reliable operation of the fork lift truck, only spare parts of the
manufacturer must be used. Used parts, oils and fuels must be disposed of in
accordance with the applicable environmental protection regulations. For oil
changes, the oil service of the manufacturer is available to you.
Upon completion of any checking and servicing activities, the operations contained in
the section “"Recommissioning”" must be performed (refer to chapter F).
2

Safety regulations applicable to truck maintenance

Servicing and maintenance personnel: The fork lift truck must only be serviced and
maintained by trained personnel of the manufacturer. The service organization of the
manufacturer has external technicians trained especially for these assignments. We
thus recommend signing a maintenance contract with the relevant service location of
the manufacturer.
Lifting and jacking up: When a fork lift truck is to be lifted, the lifting gear must only
be secured to the points specially provided for this purpose. When the truck is to be
jacked up, suitable measures must be taken to prevent the truck from slipping or
tipping over (use of wedges, wooden blocks). Work underneath the raised load lifting
device must only be carried out when the fork is immobilised and supported by a
chain of adequate strength.
f
When work has to be performed under the raised fork or under the jacked up truck,
suitable measures must be taken to prevent any dropping, tilting or slipping of the fork
or truck. When lifting the truck, the instructions contained in chapter “"Transportation
and commissioning”" have to be observed.
When performing work on the parking brake, the truck must be secured against
moving.
Cleaning operations: No inflammable liquids must be used when cleaning the fork
lift truck. Prior to commencing cleaning operations, all safety measures that are
required to prevent sparking (e.g. by short-circuits) have to be taken. For battery-
operated fork lift trucks, the battery plug must be removed. Only weak indraft, weak
compressed air and non-conducting, antistatic brushes must be used for the cleaning
of electric or electronic assemblies.
m
If the fork lift truck is to be cleaned using a water jet or a high-pressure cleaner, all
electric and electronic components must be carefully covered beforehand because
moisture can lead to incorrect functioning.
Cleaning by means of a steam jet is not permitted.
Upon completion of cleaning work, the operations detailed in the section
“"Recommissioning”" must be performed.
F 1