– Insert the fork arms as far as possible
under the load unit.
f
The fork arms must be inserted into the
load at least one third of their length.
– Engage the parking brake (3). Lift the
fork arm carriage, until the load is held
completely by the fork arms.
– Set drive direction switch (44) to
reverse travel and disengage the
parking brake.
f
Make sure the area to the rear is clear
for travelling.
– Back up carefully and slowly, until the
load is outside the storage area.
f
All personnel must stay clear of the
raised load!
Do not reach through the lifting mast.
– Carefully tilt the lifting mast backward.
– Lower the load as far as it is absolutely
necessary
clearance
200 mm).
f
When transporting loads the lifting mast
must be tilted back and the fork arms
lowered as far as possible.
for
transport
(ground
approximately
150
44
3
to
E 25