Jungheinrich EFG-Vac 25 Betriebsanleitung Seite 61

Transporting loads
f
If the load is stacked high and blocks the view to the front, you must travel backward.
–– Sensitively accelerate the truck with
the accelerator pedal (6) and carefully
decelerate it using the brake pedal (7).
Always be alert to brake immediately.
–– Adapt the
conditions of the travel paths and the
transported load.
–– Watch out for traffic at intersections
and passages.
–– In unclear situations a seconds person
should be present to give guiding
instructions.
f
At upward and downward slopes the
load must always be transported on the
hill side; never travel diagonally and
never turn around.
Setting down loads
–– Carefully approach the load-carrying
unit.
–– Engage the parking brake (3).
–– Set the mast to vertical position.
–– Lift the fork arms to the appropriate
height relative to the load-carrying
unit.
–– Disengage the parking brake.
–– Carefully drive into the load-carrying
unit.
–– Slowly lower the load until the fork
arms are free.
m
Avoid setting down the load heavily, in
order not to damage load and load-
carrying unit.
f
Bending forward with lifted load-carrying
unit only in front of or above the stack.
E 26
travel speed to the
3
7
6