Unauthorised Modification And Manufacture Of Spare Parts; Improper Use; Transport And Temporary Storage; Shipping - Wilo Stratos GIGA Betriebsanleitung

2.7 Unauthorised modification and
manufacture of spare parts
2.8

Improper use

3

Transport and temporary storage

3.1

Shipping

Transport inspection
Storage
3.2 Transport for installation/
dismantling purposes
Fig. 7: Transporting the pump
Fig. 8: Transporting the motor
Installation and operating instructions Wilo-Stratos GIGA, GIGA-D, GIGA B
Unauthorised modification and manufacture of spare parts will impair
the safety of the product/personnel and void the manufacturer's dec-
larations regarding safety.
Modifications to the product are only permissible following consulta-
tion with the manufacturer. Genuine spare parts and accessories
authorised by the manufacturer ensure safety. If other parts are used,
the manufacturer is no longer liable for any consequences which arise
from this.
The operational reliability of the supplied product is only guaranteed
for intended use in accordance with chapter 4 of the installation and
operating instructions. The limit values must on no account fall below
or exceed those values specified in the catalogue/data sheet.
The pump is delivered from the factory packaged in a cardboard box
or secured to a pallet and protected against dust and moisture.
On arrival, inspect the pump immediately for any transport damage. If
transit damage is identified, the necessary steps must be taken
involving the carrier within the specified period.
Before installation, the pump must be kept dry, frost-free and pro-
tected from mechanical damage.
CAUTION! Risk of damage due to incorrect packaging.
If the pump is transported again at a later date, it must be packaged
so that it cannot be damaged during transport.
• Use the original packaging for this, or choose equivalent
packaging.
• Check the transport eyes before use for damage and secure
fixation.
WARNING! Risk of injury!
Incorrect transport can lead to personal injury.
• The pump must be transported using approved lifting gear
(e.g. block and tackle, crane, etc.). This must be secured to the
pump flanges and, if necessary, to the outer diameter of the motor
(protection against slipping is required!).
• To lift with a crane, the pump must be supported by suitable belts, as
shown. Place the belt around the pump in loops which tighten from the
pump's own weight.
• The transport eyes on the motor are only for guiding while bearing
the load (Fig. 7).
• The transport eyes on the motor are only for transporting the
motor and are not approved for transporting the complete
pump (Fig. 8).
WARNING! Risk of injury!
Setting up the pump without securing it can lead to personal injury.
• Do not place the pump unsecured on the pump support feet. The
base with the threaded holes is used for fixation only. When stand-
ing freely, the pump might not be sufficiently stable.
DANGER! Risk of fatal injury!
The pump itself and pump parts can be extremely heavy. Falling
parts pose a risk of cuts, crush injuries, bruises or impacts, which
can be fatal.
• Always use suitable lifting equipment and secure parts against
falling.
• Never stand underneath a suspended load.
• Make sure the pump is securely positioned and is stable during stor-
age and transport as well as prior to all installation and other assembly
work.
(11-22kW)
English
73