Unauthorised Modification And Manufacture Of Spare Parts; Improper Use; Transport And Interim Storage; Transport For Installation/Removal Purposes - Wilo SiClean-Serie Einbau- Und Betriebsanleitung

English
2.7 Unauthorised modification and
manufacture of spare parts
2.8

Improper use

3

Transport and interim storage

3.1 Transport for installation/removal
purposes
4

Intended use

Purpose
Fields of application
Restrictions
16
Immediately on conclusion of the work, all safety and protective
devices must be put back in position and/or recommissioned.
Unauthorised modification and manufacture of spare parts will impair
the safety of the product/personnel and will make void the manufac-
turer's declarations regarding safety.
Modifications to the product are only permissible after consultation
with the manufacturer. Original spare parts and accessories author-
ised by the manufacturer ensure safety. The use of other parts will
absolve us of liability for consequential events.
The operating safety of the supplied product is only guaranteed for
conventional use in accordance with Section 4 of the operating
instructions. The limit values must on no account fall under or exceed
those specified in the catalogue/data sheet.
When the product is delivered, check it for any damage in transit. If
any defect is found, inform the delivery company (forwarding agent).
The equipment must be transported by means of authorised load
devices.
On arrival, inspect the product immediately for any transport damage.
If damage is found, the necessary procedure involving the forwarding
agent must be taken within the specified period.
Before installation, the product must be kept dry, frost-free and pro-
tected from mechanical damage.
CAUTION! Risk of property damage!
Improper transport and interim storage can cause damage to the
product.
• The product must not be exposed to temperatures outside the
range between -10°C and +40°C.
WARNING! Danger of personal injury!
Improper transport can lead to personal injury.
• The stability of the load must be ensured.
• The handling should be done by skilled staff and with authorised
equipment.
The basic function of SiClean is to protect heating systems against
sludge formation through continuous removal of suspended matter.
It may be used for:
• Hot-water heating systems
• Heating/air-conditioning systems
Typical installation locations are technical rooms within the building
with other domestic installations. It is not intended to install the sys-
tem directly in rooms used for residential or working purposes.
Outdoor installation is not permitted for this series.
CAUTION! Risk of material damage!
Impermissible substances in the fluid can destroy the pump. Abra-
sive solids (e.g. sand) increase pump wear. Pumps without an Ex-
rating are not suitable for use in potentially explosive areas.
• The correct use of the pump/system also includes following these
instructions.
• Any other use is considered to be incorrect use.
WILO SE 03/2018