Navigation - Wilo Stratos GIGA Betriebsanleitung

English
8.6.2 Changing to menu mode
2 s
ON
1
12.3
Fig. 34: Standard menu mode
2 s
ON
1
12.3
Fig. 35: Service menu mode
E000
Fig. 36: Fault event menu mode

8.6.3 Navigation

±
1.0.0.0
±
2.0.0.0
4.0.0.0 4.1.0.0
4.2.0.0
5.0.0.0
4.4.0.0
Fig. 37: Navigation example
100
2 s
• While the display is showing the status page, press the operating but-
±
2.0.0.0
±
5.0.0.0
±
6.0.0.0
2 s
• Change to menu mode (see chapter 8.6.2 "Changing to menu mode"
• To select the menu element, turn the operating button.
• If the downward pointing arrow for "One level down" is shown, press
4.4.1.0
4.4.3.0
• To return to the next higher menu level, select the "One level up"
• The new menu level is indicated on the display by the menu number,
To change to menu mode, proceed as follows:
ton for 2 seconds (except in event of a fault).
Standard behaviour:
The display changes to menu mode. Menu number <2.0.0.0> is
displayed (Fig. 34).
Service mode:
If service mode is activated via DIP switch 1 menu number <5.0.0.0>
is displayed first (Fig. 35).
Error case:
In the event of a fault, menu number <6.0.0.0> is displayed (Fig. 36).
on page 100).
Carry out general menu navigation as follows (for an example,
see Fig. 37):
During navigation, the menu number flashes.
The menu number is incremented up or down. The symbol associated
with the menu element and the setpoint or actual value are shown, if
applicable.
the operating button to change to the next level down. The new menu
level is labelled on the display by the menu number, e.g., when chang-
ing from <4.4.0.0> to <4.4.1.0>.
The symbol for the menu element and/or the current value (setpoint,
actual value or selection) is shown.
menu element and press the operating button.
e.g., when changing from <4.4.1.0> to <4.4.0.0>.
NOTICE:
If the operating button is pressed for 2 seconds while a "One level up"
menu element is selected, the display jumps back to the status page.
WILO SE 03/2018