Commissioning - Wilo Stratos GIGA Betriebsanleitung

No. Designation
5.8.0.0 Other settings 2
5.8.1.0 Pump kick
5.8.1.1 Pump kick
active/inactive
5.8.1.2 Pump kick
Time interval
5.8.1.3 Pump kick
Speed
6.0.0.0 Fault
acknowledgement
7.0.0.0 Access disable
Table 8: Menu structure
9

Commissioning

Safety
Preparation
Installation and operating instructions Wilo-Stratos GIGA, GIGA-D, GIGA B
Type Symbol Values/explanations
ON
Confirming will reset the
settings to factory settings
Caution!
All manual settings will be lost
±
ON (factory setting)
Pump kick is activated
OFF
Pump kick is deactivated
±
Can be set between 2 h and 72 h
in 1 h steps
±
Can be set between the pump's
minimum and maximum speeds
±
For additional information, see
chapter 11.3 "Acknowledge
fault" on page 122
±
"Access disable" inactive
(changes possible)
(for further information, see
chapter 8.6.7 "Activating/
deactivating access disable" on
page 102)
"Access disable" active (no
changes possible)
(for further information, see
chapter 8.6.7 "Activating/
deactivating access disable" on
page 102)
DANGER! Risk of fatal injury!
Failure to install safety devices of the electronic module and the
motor can cause electrical shock or contact with rotating parts,
potentially resulting in life-threatening injuries.
• Before commissioning as well as after maintenance work, all safety
devices such as module covers and fan covers that were removed
must be reinstalled.
• Keep a safe distance during commissioning.
• Never connect the pump without the electronic module.
Before commissioning, the pump and electronic module must be at
the ambient temperature.
(11-22kW)
English
Display conditions
Is not displayed when access
disable active. Is not
displayed when BMS is active.
For parameters that are
changed by a factory setting,
see chapter 13 "Factory
settings" on page 128
Not displayed for all pump
types.
Is not displayed if pump kick
is deactivated
Is not displayed if pump kick
is deactivated
Only displayed if an error is
present
109