Disposal - Wilo Stratos GIGA Betriebsanleitung

14

Disposal

Oils and lubricants
Information on the collection of used
electrical and electronic products
Installation and operating instructions Wilo-Stratos GIGA, GIGA-D, GIGA B
Menu no. Designation
4.3.1.0 Base-load pump
5.1.1.0 Operating mode
5.1.3.2 Internal/external pump
cycling
5.1.3.3 Pump cycling time interval
5.1.4.0 Pump enabled/disabled
5.1.5.0 SSM
5.1.6.0 SBM
5.1.7.0 Extern off
5.3.2.0 In1 (value range)
5.4.1.0 In2 active/inactive
5.4.2.0 In2 (value range)
5.5.0.0 PID parameter
5.6.1.0 HV/AC
5.6.2.0 Emergency operation
speed
5.6.3.0 Auto reset time
5.7.1.0 Display orientation
5.7.2.0 Pressure value correction
5.7.6.0 SBM function
5.8.1.1 Pump kick active/inactive
5.8.1.2 Pump kick interval
5.8.1.3 Pump kick speed
Table 13: Factory settings
Proper disposal and appropriate recycling of this product prevents
damage to the environment and danger to your personal health.
Disposal in accordance with the regulations requires the product to be
drained and cleaned.
Operating fluid must be collected in suitable tanks and disposed of in
accordance with the locally applicable guidelines.
NOTICE:
Disposal in domestic waste is forbidden!
In the European Union, this symbol can appear on the product, the
packaging or the accompanying documentation. It means that the
electrical and electronic products in question must not be disposed of
along with domestic waste.
To ensure proper handling, recycling and disposal of the used prod-
ucts in question, please note the following points:
• Only hand over these products at designated, certified collecting
points.
• Observe the locally applicable regulations!
Please consult your local municipality, the nearest waste disposal
site, or the dealer who sold the product to you for information on
proper disposal. Further recycling information can be found at
www.wilo-recycling.com.
Subject to change without prior notice!
(11-22kW)
English
Factory-configured values
MA
Main/standby operation
Internal
24 h
Approved
Collective fault signal
Collective run signal
Collective Extern off
0–10 V active
OFF
0-10 V
See chapter 9.4 "Setting the
control mode" on page 111
HV
Approx. 60 % of n pump
max
300 s
Display on original orientation
Active
SBM: Run signal
ON
24 h
n
min
129