Cleaning And Care; St Or Ing The Ap P Lia Nc E - SOLIS EASYVAC Professional Typ 572 Bedienungsanleitung

Cl EA ninG A nd CA r E
s
To clean your vacuum-appliance, please proceed as follows:
1. Always pull the power plug from the socket and the connection plug from the
appliance jack.
2. Never submerge the appliance in water or hold it under running water.
3. Do not use aggressive cleaning agents, solvents or abrasive materials for cleaning
with appliance, these could damage the surfaces.
4. Wipe clean the appliance including the sealing rings, the sealing bar and the
vacuum chamber with a mild detergent and a soft, moist cloth.
5. Leave the appliance to completely air dry, before storing or using the appliance.
6. The appliance must not be oiled.
• NOTE: The seals around the vacuum chamber should also be completely dry.
If you take them out for a thorough clean then put them back in place, then
they must be put back in exactly the same position so that no air can enter the
vacuum chamber.
Po WEr - C A blE S to rA GE
If the appliance is not in use, the power cable should be rolled up and placed in the
cable compartment on the back side of the appliance. Never wrap the cord around
the appliance!

St or inG thE AP P liA nC E

s
• CAUTION: Before storing, always check that the cover of the appliance is
not locked shut! Otherwise the seals will become no longer airtight.
Store the appliance in a flat dark place, out of reach of children, at best in it's origi-
nal packaging. The vacuum sealer must rest on it's base and not lie on it's side since
this could cause damage to the appliance which would not be covered by warranty.
The appliance cover has to stay open and the handle must not be locked into place.
Moreover, nothing should be placed on top of the appliance so that there is no
pressure on the seals. Seals are consumables and are not covered by warranty.
121