SOLIS EASYVAC Professional Typ 572 Bedienungsanleitung Seite 122

Pro blE mS And P o S S i bl E
s
CAu S ES
t hE A P P l i An CE d oE Sn 't Work
1. Check if the power plug and the connection plug are properly plugged into the
power socket resp. the appliance jack.
2. Check if the ON/OFF switch on the back side of the appliance is in the „I"-posi-
tion.
3. Check whether the power cable is damaged. If this is the case, bring the appli-
ance to SOLIS or a SOLIS approved service centre to get the cable replaced.
4. Check whether the socket is working by connecting another electrical device.
5. Check that the end of the bag is correctly in the vacuum chamber. The bag must
not cover the air vent.
6. The vacuum sealer switches off automatically if it overheats. Let it cool down first
before starting to use it again.
t hE A P P l i An CE i S n ot SE A lin G An E mP t Y b AG
Check that the end of the bag is lying correctly on the contact rubber, as is
described in section 5 (Page 106).
t hE A i r i S no t ComPlE tE lY S uC k E d ou t
of t hE b A G
1. So that the bag gets completely sealed, the open end of the bag must lie com-
pletely in the vacuum chamber without any wrinkles. The bag must not cover the
air vent.
2. Check that the sealing bar and the seals around the vacuum chamber are free
from dirt and in the correct position. Also, the seals must not be broken or
porous. Clean the seals and the sealing bar.
3. Check whether the bag has a hole in it. To do this, seal the bag with some air in
it and submerge it in water. If bubbles rise from it, it is leaking, use another bag.
4. Use bags and films from SOLIS exclusively!
5. Possibly the bag is not tightly welded because crumbs, fat or liquids are in the
welds or because the bag end was not even and without creases. Open the bag,
clean the end of the bag inside and out and the sealing bar and make sure that
the end of the bag is lying completely flat in the vacuum chamber.
122