Cleaning And Care; Sto R In G T He A P P Lia Nce - SOLIS EASYVAC PRO Typ 569 Bedienungsanleitung

Cl EA ni nG An D CA RE
s
To clean your vacuum-appliance, please proceed as follows:
1. Always first pull the plug out of the socket.
2. Never submerge the appliance in water or hold it under running water.
3. Do not use aggressive cleaning agents, solvets or abrasive materials for cleaning
with appliance, these could damage the surfaces.
4. Wipe the appliance with mild cleaning agents and with a soft, damp cloth.
5. Leave the appliance to completely air dry, before storing or using the appliance.
6. Your appliance must not be oiled.
• Note: The seals around the vacuum chamber should also be completely dry.
If you take them out for a thorough clean then put them back in place, then
they must be put back in exactly the same position so that no air can enter the
vacuum chamber.
ClEA n i nG V A Cu u m C O n t A i n E RS
1. The containers without the lids can be hand washed in warm, soapy water.
2. Attention: Do not immerse the lids of the containers into water and don't
put them into a dishwasher. The inner cap underside of the container
lid can be removed and washed. Clean the lids themselves only with a
damp cloth. Allow them to dry thoroughly and re-insert the cap on the
underside of the lid.
3. Allow all accessories to dry completely, before storage or use.
4. We recommend, to keep the rubber seals elastic, to rub them from time to time
with a few drops of cooking oil.

StO R in G t hE A P P liA nCE

s
• Caution: Before storing, always check that the lid of the appliance is not
locked shut! Otherwise the seals will become no longer airtight.
Store the appliance in a flat dark place, out of reach of children, at best in its
original packaging. The vacuum sealer must rest on its base and not lie on its side
since this could cause damage to the appliance which would not be covered by
warranty.
The upper cover must remain open with the locking catches disengaged. More-
over, nothing should be placed on top of the appliance so that there is no pressure
on the seals. Seals are consumables and are not covered by warranty.
84