Sensor Position; Position Of Vehicle On Measurement Bay - Bosch FWA 46xx + Originalbetriebsanleitung

4.3

Sensor position

Abb. 12: Sensor (on left/right) of vehicle
i
The sensors have fixed positions (left/right) on the
vehicle as shown by the pictogram. Details can be
found in the "Commissioning" document.
i
Make sure the vehicle is driven centrally and straight
onto the measurement bay.
Robert Bosch GmbH
Operation | FWA 46xx + | 35 | en
4.4 Position of vehicle on measurement
bay
Abb. 13: Position of vehicle on measurement bay
1 max. Rolling distance 250 mm
2 Safety clearance 200 mm
1. Pay attention to the minimum distance between the
center of the turntable and the center of the sensor,
950 mm (X). Position the turntable accordingly on
the measurement bay.
i
Short wheelbase: Heed (refer to table) maximum
distance between outer edge of platform and outer
edge of tire (Y).
Wheelbase [mm] X [mm]
1900 – 2400 950
2400 – 4300 1450 – 1750
2. Measure the sensor spacing.
Abb. 14: Sensor spacing measurement points
3. Enter the spacing of the two sensors under
<Maintenance><Options><System settings>
<Distance Reference System>.
i
For lifting platforms with adjustable runways, make
sure the correct spacing value has always been
stored in the program.
Y [mm]
0-200
–
|
1 690 706 098 2017-11-27