VDO Logic Log Depth Montageanleitung Und Bedienungsanleitung Seite 72

BASIC SETTINGS
Go to start point A of the measuring distance and hit the "ENTER" key
when you pass start mark A.
Cover the measuring distance in a straight run, and hit the "ENTER" key again
when you pass target mark B. The calculated calibration factor (1.15 in this ex-
ample) is displayed, and is stored when the "ENTER" key is hit.
The following example 2 refers to a measuring run in flowing water, the
measuring distance (A - D) being 2.7 nautical miles.
Example 2:
Set the distance read from the map with the "CLEAR" key and the "UP
ARROW" key (2.70 nm in this example).
Hold down until:
72