Automatic Recording With Adjustable Cycle Time "Func-Cycl - WIKA CPH62I0 Betriebsanleitung

6. Commissioning, operation
Logger memory is full
If the logger memory is full, the display will show:
Reviewing individual values
In contrast to the cyclic logger function, individual values can also be viewed directly in
the display:
1. Press the [SET/MENU] button for 2 seconds.
⇒
Menu item "rEAd-Lo66" will be accessed.
2. With the [TARA] button, the last measuring result is displayed.
3. Press the [TARA] button again.
⇒
Individual values of the measuring result are displayed.
4. With the [MIN] or [MAX] buttons, recall some further measuring results.
5. Press the [TARA] button.
⇒
Individual values of the new measuring result are displayed.
6. Press the [SET/MENU] button.
⇒
Return to main menu.

6.5.2 Automatic recording with adjustable cycle time "Func-CYCL"

The logger cycle time is adjustable (see configuration). As an example "CYCL" = 1:00 a
measuring result will be stored every minute.
Additionally, with the measurement type "rAtE SLo", a current-saving function is
selectable, "Lo.Po". If this is "on", it operates so that, while the logger is recording,
a measurement only occurs at the respective logger time. This reduces the power
consumption considerably and is therefore mainly recommended for long-term
measurements (e.g. leak testing).
Recordable measuring results:
Cycle time:
A measuring result contains:
Slow measurements "rAtE-SLo":
■
- Sensor 1: Current measured value at that data point
- Sensor 1: Min. peak, Max. peak since last data point
1)
- Sensor 2 : current value at that data point
1)
- Sensor 2 : Min. peak, Max. peak since last data point
- Difference (sensor 1 - sensor 2)
- Difference sensor 1 - sensor 2
WIKA operating instructions, model CPH62I0
CPH62I0-S1: 10,000
CPH62I0-S2: 4,000
(at max. 64 recording sequences)
1 ... 3,600 s (= 1 h),
adjustable in the configuration
1)
: current value at that data point
1)
: Min. peak, Max. peak since last data point
EN
33