Pressure Sensors; Available Pressure Sensors - WIKA CPH62I0 Betriebsanleitung

4. Design and function
The battery indicator lights up
To avoid false readings, replace the batteries.
If "bAt" is displayed in the lower display, the battery has been run down and
EN
must be replaced. However, the instrument function is still ensured for a
certain time.
If "bAt" is displayed in the upper display, the battery has been completely
run down.
If the instrument is not used for a long time, the battery should be removed.
The real-time clock has to be set again once the battery has been
reconnected.
The battery must only be used in a proper fashion and must be disposed
of properly in line with the current, national regulations. When storing the
instrument at over 50 °C (122 °F), the battery must be taken out.

4.5 Pressure sensors

DANGER!
Danger to life due to loss of explosion protection
Non-observance of these instructions and their contents may result in the
loss of explosion protection.
If third-party reference pressure sensors are used, they can damage the
hand-held pressure indicator and the reference pressure sensor.
▶
▶

4.5.1 Available pressure sensors

The hand-held has been designed so that all model CPT62I0 pressure sensors can
be connected without the need for any readjustment. A wide range of interchangeable
sensors is therefore available, with ranges of up to 1,000 bar (14,500 psi), see
10 "Specifications".
18
Only use model CPT62I0 reference pressure sensors!
Only ever use the original connection cable from WIKA for the operation of
CPT62I0 reference pressure sensor.
WIKA operating instructions, model CPH62I0