Menu Functions - WIKA CPH62I0 Betriebsanleitung

6. Commissioning, operation
After changing the battery the menu for setting the clock is displayed automatically
('CLOC'). Check the clock and adjust if necessary (see chapter 6.4.11 "Real-time clock
(CLOC)").

6.3 Menu functions

Menu Parame-
ter
▶
[MENU]
Set Configuration: General settings
SE
t
ConF
Unit
SL
ALti
rAtE
t.AU6
P.oFF
Ovt
Adr.
dAC.
dAC.0
dAC.1
1) If there is data in the logger memory, this menu item cannot be accessed. If these should be changed, the data must first be
deleted (see chapter 6.5 "Operation of the logger function").
2) This menu can only be selected if an appropriate sensor is connected to connection 1. When using a second corresponding
sensor on connection 2 then the settings are adopted.
3) If the automatic recording is activated, this menu item cannot be accessed. If these should be changed, the cyclic data logger
must first be stopped (see chapter 6.5 "Operation of the logger function").
WIKA operating instructions, model CPH62I0
Values Meaning
▲ ▼
or
mbar, bar, ... Display of unit
Sea level: Switch sea-level correction on or off
oFF / on
-200 ... +9999 Altitude: Input of altitude above sea level [metre] (only if SL is
activated)
Rate: Measuring rate (see chapter 6.4.3 "Measurement types (rAtE)")
Slow: Slow measurement (4 Hz filtered, low power
SL o
consumption)
Fast: Fast measurement, filtered (> 1,000 Hz)
FASt
Peak detection: fast measuring rate, unfiltered (> 1,000 Hz)
P.dEt
1 ... 120 Time in seconds, calculated via the averaging function
Averaging deactivated
oFF
Auto power-off delay in minutes.
1 ... 120
If no button is pressed and there is no data transfer via the
interface, the instrument will switch itself off after this interval.
Auto power-off function deactivated (continuous operation)
oFF
No output function, lowest power consumption
oFF
Instrument output is serial interface
SEr
Instrument output is analogue output 0 ... 1 V
dAC
01, 11 ... 91 Communications address of the interface (only with Out =
SEr )
CH1, CH2 or Measuring input which should be used for the analogue
output (only with Out = dAC)
CH DIF
e.g. -5.00 Zero point setting for Out = dAC: Input of the measured value
...+5.00 mbar at which the analogue output should output 0 V (only for Out
= dAC)
e.g. -5.00 Scale setting for Out = dAC: Input of the measured value
...+5.00 mbar at which the analogue output should output 1 V (only for
Out = dAC)
1) 2)
1) 2)
1)
3)
EN
1) 2)
1)
1)
1)
3)
23