WIKA CPH62I0 Betriebsanleitung Seite 37

7. Faults
WARNING!
Physical injuries and damage to property and the environment caused
by hazardous media
Upon contact with hazardous media (e.g. oxygen, acetylene, flammable
or toxic substances), harmful media (e.g. corrosive, toxic, carcinogenic,
radioactive), and also with refrigeration plants and compressors, there is a
danger of physical injuries and damage to property and the environment.
Should a failure occur, aggressive media with extremely high temperature
and under high pressure or vacuum may be present at the instrument.
▶
For these media, in addition to all standard regulations, the appropriate
existing codes or regulations must also be followed.
▶
Wear the requisite protective equipment.
For contact details see chapter 1 "General information" or the back page of
the operating instructions.
Display Cause
Low battery voltage, functioning is
only guaranteed for a short period of
time
Battery is empty
There is no sensor connected
SEnS
Erro
Connected sensor or instrument is
defective
or
Err.9
Reading is significantly above or
below the measuring range
- - - - Logger data is being read by the
- - - - serial interface
WIKA operating instructions, model CPH62I0
Measures
Insert new battery, see chapter
8.2 "Battery replacement"
Insert new battery, see chapter
8.2 "Battery replacement"
Switch instrument off and connect
sensor.
If second sensor available, check if
instrument is OK. Return defective
instrument/sensor to manufacturer
for repair.
Check: Is the pressure within the
permissible measuring range of the
sensor?
Increase or decrease the pressure
correspondingly.
Check the pressure measuring range
of the sensor and, if necessary,
replace with a suitable sensor.
As soon as the data transfer is
complete, the instrument will return to
normal measuring mode, no remedy
necessary.
EN
37