WIKA CPH62I0 Betriebsanleitung Seite 34

6. Commissioning, operation
Fast measurements "rAtE-FASt" or "rAtE-P.dEt":
■
- Sensor 1: Arithmetic mean value since last data point
- Sensor 1: Min. peak, Max. peak since last data point
1)
- Sensor 2
EN
1)
- Sensor 2
- Difference sensor 1 - sensor 2
- Difference sensor 1 - sensor 2
1) Only valid for 2-channel version, CPH62I0-S2
Starting logger recording
1. Press the [STORE/QUIT] button for 2 seconds.
⇒
The display shows "Lo66 rvn":
2. Press [STORE/QUIT] button once more.
⇒
Recording starts.
⇒
With each recording, the display will shortly show "St.XXXX". Here, XXXX is the
number of the data set 1 ... 4,000 or 1 ... 10,000.
⇒
If the logger memory is full, the display will show:
⇒
The recording will be stopped automatically.
With the low-power-logger function "Lo.Po = on", the instrument switches
itself off as soon as the logger memory is full.
Stopping the logger recording:
1. Press the [STORE/QUIT] button briefly.
⇒
A confirmation prompt then appears:
2. With the [MIN] or [MAX] button, select the desired function.
34
: Arithmetic mean value since last data point
: Min. peak, Max. peak since last data point
1)
1)
: arithmetical mean value since last data point
: Min. peak, Max. peak since last data point
WIKA operating instructions, model CPH62I0