Operation Of The Logger Function - WIKA CPH62I0 Betriebsanleitung

6. Commissioning, operation
8. With the [MIN] or [MAX] buttons, enter the year.
9. With the [STORE/QUIT] button, confirm the entry.
10. Press the [SET/MENU] button.
⇒
Return to main menu.
After changing the battery, the menu for setting the clock is automatically started after
switching on the instrument.

6.5 Operation of the logger function

Generally, the instrument supports two different logger functions which one activates via
the main menu. After activating the data logger in the main menu, the arrow is shown at
'Logg' in the main display. Subsequently, recording can be started as follows:
"Func-SToR"
▶
Press [STORE/QUIT] button.
⇒
A measuring result is recorded in each case.
"Func-CYCL"
▶
Press the [STORE/QUIT] button for 2 seconds.
⇒
'Lo66 rvn' shows in the display,
▶
Press [STORE/QUIT] button once more.
⇒
Recording is started.
⇒
The measuring results will automatically be recorded at the interval of the set
cycle time.
The logger records up to three measuring results:
Measured value or mean value (depending on selected function)
■
Min. value and max. value (Sensor 1, sensor 2, difference)
■
To evaluate the "Func-CYCL" data, WIKA's GSoft (V 2.3 or higher) data logger evaluation
software must be used. The software also allows easy configuration and operation of the
logger.
When the logger function "Func-Stor" or "Func-CYCL" is activated (see menu navigation
for the main menu), the hold function is not available.
Min. and Max. value are, respectively, the minimum and the maximum measured value
during the last save operation. Therefore both the current pressure value and also any
pressure fluctuations can be accurately analysed.
WIKA operating instructions, model CPH62I0
EN
31